an801: DSCA Calibration Procedure

Application Note

  1. Using the module data sheet or module top label, determine the input and output ranges of the module. Connect a precision voltage source, current source, frequency source, RTD simulator, resistance or thermocouple simulator as appropriate to the input of the module. Set the input source to the value shown below.

    table 1


  2. Locate the required output signal in the table below. Turn the Zero Adjust Potentiometer (marked with the ‘0’ symbol) to obtain the module output shown:

    table 2

  3. Set the module input source to the positive full scale input value
  4. Turn the Span Adjust Potentiometer (marked with the two-headed arrow symbol) to obtain the positive full scale module output.

** DSCA33-xx requires the following calibration sequence for non-interactive adjustments.
  1. Set the module input to 10% full scale and record the module output. This is Meas. #1.
  2. Set the module input to 100% full scale and record the module output. This is Meas. #2.
  3. Calculate the required module full scale output as follows: Required Output = Meas. #2 1.1*(Meas. #2 Ideal Full Scale Output (Meas. #1 Ideal 10% Output)
  4. Turn the Span Adjust Potentiometer to obtain the calculated value of Required Output.
  5. Set the module input to 10% full scale.
  6. Turn the Offset Adjust Potentiometer to obtain Ideal 10% output. (i.e. 1V for 0V to 10V output module).
Download PDF

Download a PDF version of this content.

Was this content helpful?
Thank you for your feedback!
Menu
Top