Serial Data

Tech Note

From all the articles on "fieldbuses", that is - Profibus, DeviceNet, CAN, ModBus, and others, one would think that these busses dominate. NOT TRUE! Good old RS-232 and RS-485 are still used in over 75% of process control networks.

To connect and protect devices on RS-485, Dataforth offers a fully isolated DIN rail converter / line driver, our DCP485. Dataforth's compact DIN package features a complete electrical isolation barrier and heavy-duty surge protectors rated to 1500Vrms (continuous) isolation, 6000 VDC (1 minute) surge and inherent 15KV ESD protection.

Links:
DCP485 Selection
DCP485 (PDF) specification sheet

Please feel free to contact our applications engineers at support@dataforth.com should you need any product selection assistance.

The DCP485 series provides many benefits over older designs:

  • Operates at the signal level
  • No addresses to set or program
  • Transparent to software and operating system
  • Data rates of 0 to 115.2K baud (bits per second)
  • Full duplex operation over two wire pairs
  • Four diagnostic LED indicators
  • May be powered from +10 to +30 VDC
  • Connections are made through pluggable screw terminals
  • You may multidrop up to 32 units
  • Provides RTS, DTR, or Auto RS-485 transmitter control
  • Operation over -40C to +60C temperature range
  • MTBF exceeds 100,000 hours
  • Block diagram / instructions on the nameplate
  • Competitively priced (call factory for details)

Was this content helpful?
Thank you for your feedback!
Menu
Top